Safety Information

Transportation

  • The scanner may only be transported if it has been properly packed and secured.

  • When laying the cables, ensure that they do not pose a tripping hazard. Always lay the cables along walls. Under no circumstances may the cables be routed so that they are under tension or sagging.

  • No liquids should come into contact with the scanner. Do not place any vessels with liquid on the scanner.

Installation

  • The operating and maintenance personnel must be instructed regularly on the operation of the system and on potential hazards. They are required to read the operation manual.

  • Before each start-up, make sure that there are no parts in the swivel range of the arm, as it performs a reference run when switched on.

  • Power supply and feeder cables must not be damaged or crushed by other objects.

  • Malfunctions or damage must be reported to the operator immediately.

  • If the scanner is not in use for a longer period of time, disconnect it from the power supply.

Intended use

The intended use of the scanner is the digitizing of small parts of different objects (metal, art, etc.) with metrology-grade accuracy in combination with Artec Studio.

Various objects can be inserted with a maximum weight of 2000 g and dimensions W x L x H: 200 mm x 200 mm x 150 mm. Only accessories recommended by Artec 3D may be used. Improper use of this scanner may endanger persons and damage the scanner. The product is not an automatically functioning device; it must be loaded manually. Furthermore, any liability and warranty claims are excluded in the event of non-compliance with the intended use.

Warning

Micro II is equipped with a compact LED projector. Avoid staring directly into the light source of the projector. Micro II is designed to minimize the risk of accidental exposure when the operator adheres to the provided instructions and safety precautions. However, accidental exposure can still cause discomfort, irritation, or even injury. If you experience any discomfort after accidental exposure, please consult your healthcare provider.

Intended environment

  • Indoors operation only

  • Ambient temperature: 5 °C to 35 °C

  • Relative humidity: up to 31°C 20 % - 80 % at temperatures up to 35°C maximum 20-50% linear decreasing - not suitable for humid rooms, non-condensing

  • No flickering light

  • Maximum ambient brightness 500lux. No direct sunlight in the scanning area

  • Clean and dust-free environment

  • Horizontal installation site on a stable, vibration-absorbing workstation

  • Maximum installation altitude <2000m above sea level

Warning

Repairs to the scanner may only be performed by authorized Artec 3D Service Centers.

Please refer to the full version of this manual for more safety instructions (About This Manual).