First Steps with Leo

Setting up Artec Leo is easy and includes the following steps:

Turn On

  1. Take Leo out of the case and place it vertically on a flat rigid surface.

  2. Press the power button button near the screen (see Meet Leo, 3).

  3. If the scanner hasn’t booted up, try plugging it to the power adapter.

Note

When you turn on the Leo scanner later after its activation, you may be prompted to enter a password. This happens if storage encryption has been previously enabled.

Plug In Power Adapter

  1. Get familiar with the safety recommendations.

  2. Plug the Leo DC-cable into the round port on scanner base.

_images/le_setup_charge.svg

Caution

Never use DC cables and adapters designed for other Artec scanners (Eva, Spider, etc.)

  1. Connect the power cord to the power adapter.

  2. Plug the power cord into the power outlet.

Read License Agreement

Once the scanner is turned on, it will show the greeting screen with the license agreement. Read it carefully and, if you agree to the terms, Accept it.

Connect to the Internet

The initial Leo activation requires an Internet connection; afterwards, you can use the scanner offline.

Wi-Fi

To connect to a Wi-Fi network,

  1. Wait for the required network to appear in the list.

  2. Tap the network that you intend to join.

  3. Enter the password (key) for this network and tap Connect. Once you are connected to a Wi-Fi network, icon wifi will appear in the top status bar.

Wired Connection

To create a wired connection, plug the Ethernet cable into the scanner as the figure depicts. If the network is configured as DHCP, the connection will be established automatically and icon wired will appear in the top status bar.

_images/le_ethernet.png

Activate Leo

To activate your Leo, you need a valid account at my.artec3d. Use the account your Artec reseller registered for you, or create a new account using either a mobile device or a computer.

  1. In the Network screen, tap Next.

  2. Enter your email for my.artec3d.

_images/le_setup_mya.png

  1. Tap Next.

  2. Enter your password and tap Next.

  3. In the new dialog that appears, enter a name for your Leo.

  4. Tap Done.

Your Leo is now ready for operation.

Apply Serial Number Sticker

The envelope that comes with Leo scanner contains the serial number sticker. Place it on the underside of your Leo battery housing.

_images/leo_bottom.png

Figure 1 Place the serial number sticker on the empty rectangle.